Burst pipe repair is an important and necessary service whenever you have a burst pipe on your property.
If you would like to take on your burst pipe repair, you will need some tools and materials to start the process. Therefore, it would be highly recommended to hire experts from plumbingfremontca.com/bursted-pipe for your broken pipes.
These materials include a mini copper-pipe cutter, steel wool, lead-free solder, soldering paste, a torch kit (which includes a torch and striker). You will also need a good ½ inch copper pipe, a stop and waste valve, and ½ inch copper fittings.
The steps are extensive. However, the first step is the most important: shut off the main valve where water comes into the house. The lowest fixture in the house can be used to drain the water.
A pipe cutter can be used to remove the desired section of the pipe. A section of copper pipe should be cut to fit the specified section. The steel wool can next be used to clean both the pipe and inside the stop and waste valve.
Next, spread soldering flux on the outside of the pipe end and inside the valve fitting. After that has been done, you can slide the valve fitting on the end of the pipe. With safety goggles in place, you can use a propane torch to heat the fitting and the pipe where they connect.
At this point, you can push about two inches of solder into the joint where the valve connects to the pipe. As always, it is important to utilize safety precautions. You should always contact a reputable plumber to oversee any important plumbing process.